Oceanic OCEATG4S1 Notice D'utilisation page 36

T
H
C
• Place the hob in the cut out. Mark the
location of the hob on the cooktop.
Marker
Hob
• Remove the hob. Place the gasket on
the line you marked. Make sure that the
line centres the gasket. Ensure that the
junctions overlap at the corners and no
gap is left along the sealing material.
Gasket
Line
you
marked
• Insert the appliance into the aperture
and fix in position using the brackets
(A) and screws (B). Adjust the position
of the brackets depending on the
thickness of the worktop and tighten the
screws evenly. Carefully trim away any
B
Separator
A
Worktop
EN - 13
I
J
excess sealing material (C) from around
the appliance.
C
Hob
A t<25 mm
B
2.3 gAs connection
Assembly of gas supply and leakage
check
Connect the appliance in accordance
with applicable local and international
standards and regulations. First, check
what type of gas is installed on the cooker.
This information is available on a sticker
on the back of the cooker. You can find
the information related to appropriate gas
types and appropriate gas injectors in
the technical data table. Check that the
HOB
Separator
F
G
C
Hob
A
t>25 mm
B