Samsung HW-Q995D Guide De L'utilisateur page 4

Using the Surround speaker mode
An optimal surround sound may be delivered depending
on the position of the surround speaker.
For more information, refer to the speaker section of the
Full manual.
04 USING A WIRED
CONNECTION
1
HDMI Cable
2
Optical Cable (not supplied)
HDMI IN
(ARC)
HDMI OUT
Connecting using an HDMI Cable
(External Device (HDMI 1 or HDMI 2) / TV ARC/eARC)
OPTICAL OUT
Connecting using an Optical Cable (D.IN)
NOTE
• When the TV sound is not output, press the
Function) button at the top of the Soundbar or the
(Source) button on the remote control to select
the "TV ARC" mode.
• The recommended cable is an HDMI cable certified
by HDMI.org.
• When you use an optical cable and the terminals
have covers, be sure to remove the covers.
CH LEVEL
1 HDMI TO TV
(eARC/ARC)
HDMI 1
1
HDMI 2
2 DIGITAL AUDIO IN
(OPTICAL)
1 I M D H
2 I M D H
(Multi
SOUND
MODE
WOOFER
CH LEVEL
CONTROL
SOUND
MODE
WOOFER
TONE
CONTROL
ENG - 4
Using the Q-Symphony Function
When the Soundbar connects to a Samsung TV that
supports the Q-Symphony function, you can play the
sound simultaneously through the Soundbar and the TV.
If you use the Q-Symphony function, the surround sound
played on the TV allows you to enjoy a richer, more
three-dimensional surround sound effect.
When the Soundbar is connected, "Q-Symphony" menu
appears on the TV. (The message displayed may differ
with the TV model.)
(Settings ( ) → All Settings (
Output)
Using the SpaceFit Sound
This function analyzes the user's listening space with the
Soundbar's microphone and provide optimal sound for
the space. Sound optimization proceeds automatically.
05 USING A WIRELESS
CONNECTION
Connecting via Bluetooth
Top of the Soundbar
BT PAIRING
OR
• Search for the Bluetooth device on your TV or mobile
device.
What is the difference between BT READY and BT
PAIRING?
TONE
• BT READY : In this mode, you can reconnect any
Samsung TV or mobile device that was connected
before.
• BT PAIRING : In this mode, you can connect a new
device to the Soundbar.
(Press the PAIR button on the Soundbar remote
control or press and hold the
on the top of the Soundbar for more than 5 seconds
while the Soundbar is in "BT" mode.)
NOTE
• If asked for a PIN code when connecting a Bluetooth
device, enter <0000>.
) → Sound → Sound
5 sec
OR
(Mic On/Off) button