Publicité
Les langues disponibles
Les langues disponibles
The compressor runs for longer in order to rapidly cool the
u
food. This is normal.
The inverter regularly flashes every 15 seconds*.
→
The inverter is equipped with a diagnostic LED.
The flashing is normal.
u
Excessive noise.
Speed-controlled* compressors may produce varying
→
running noise due to different speed steps.
The sound is normal.
u
A bubbling and gurgling noise.
This noise comes from the refrigerant flowing in the refriger-
→
ation circuit.
The sound is normal.
u
A quiet clicking noise.
→
The noise is produced whenever the refrigeration unit
(motor) automatically switches on or off.
The sound is normal.
u
A hum. It is briefly a little louder when the refrigeration
unit (the motor) switches on.
The refrigeration increases automatically when Fast-Freeze
→
is activated, fresh food has just been placed in the appli-
ance or the door has been left open for a while.
The sound is normal.
u
The ambient temperature is too high.
→
Solution: (see 1.2)
u
A low hum.
The sound is produced by air flow noise of the fan.
→
The sound is normal.
u
The temperature display indicates: F0 to F5.
There is a fault.
→
Contact the customer service (see Maintenance).
u
The temperature display indicates: nA
→
The freezer temperature rose too high over the last hours or
days due to a power failure or power interruption. When the
power interruption is over, the appliance will continue to
operate in the last temperature setting.
Fig. 2 (6)
u Press alarm button
w The warmest temperature reached during the power failure
will appear in the temperature display for about 60 s. After
that, the actual temperature in the freezer will re-appear.
u To prematurely cancel the display of the warmest tempera-
Fig. 2 (6) .
ture: press alarm button
u Check the quality of the food. Do not consume spoiled food.
Do not re-freeze thawed food.
The temperature is not cold enough.
→
The door of the appliance is not properly closed.
Close the door of the appliance.
u
Insufficient ventilation.
→
Clear ventilation grilles.
u
→
The ambient temperature is too high.
Solution: (see 1.2) .
u
→
The appliance was opened too frequently or for too long.
Wait until the appliance reaches the required temperature
u
itself. If not, contact the customer service. (see Mainte-
nance).
→
Too much fresh food was placed inside without Fast-
Freeze.
Solution: (see 5.8)
u
The temperature is incorrectly set.
→
Set to a colder temperature and check after 24 h.
u
→
The appliance is too close to a heat source.
Solution: (see Putting into operation).
u
The appliance was not inserted properly into the recess.
→
Check whether the appliance was inserted correctly and
u
the door closes properly.
Decommissioning
8 Decommissioning
8.1 Switching off the appliance
Fig. 2 (4) for about 2 s.
u Press On/Off button
w The temperature display is dark.
8.2 Taking the appliance out of service
u Empty the appliance.
u Pull out the power plug.
u Clean the appliance (see 6.2) .
u Leave the door open to prevent odour.
9 Disposing of the appliance
The appliance contains some reusable materials
and should be disposed of properly - not simply
with unsorted household refuse. Appliances which
are no longer needed must be disposed of in a
professional and appropriate way, in accordance
with the current local regulations and laws.
When disposing of the appliance, ensure that the refrigeration
circuit is not damaged to prevent uncontrolled escape of the
refrigerant it contains (data on type plate) and oil.
u Disable the appliance.
u Pull out the plug.
u Cut through the connecting cable.
23
Publicité
