Flama 1319FL Manuel D'instructions page 29

EMPTYING THE WATER TANK
When the tank is full, the dehumidifier will
make a buzzing sound and the "full tank"
light will turn on.
Press the POWER button to turn off the
dehumidifier.
Pull on the water tank and simply slide it
out of the dehumidifier.
Empty the water down a drain or outside.
Clean the interior and exterior of the tank.
Return the empty tank to the dehumidifier.
Press the POWER button to continue
operation.
If the "full tank" light does not turn off,
check that the tank and the float are
correctly positioned.
Notice
Do not discard the water tank magnets and
plastic rivets. Otherwise, the dehumidifier
will not automatically stop working when
the water tank is full, and the condensed
water will overflow and damage the floor
of the room it is in.
Make sure to clean the condensed water in
the water tank before restarting operation
of the dehumidifier.
If the water tank is dirty, rinse it with clean
water. Avoid using detergents, chemical
dust removers, diesel oil, benzene,
thinners or other solvents. These will
damage the water tank and cause leaks.
Return the empty tank to the dehumidifier.
Otherwise, the full tank indicator will
remain red and the dehumidifier cannot
restart.
CONTINUOUS DRAINAGE
For continuous operation or automatic
dehumidification, connect the drain hose
to the dehumidifier. The condensed water
can automatically flow to a bucket or drain
by gravity.
Straighten the drainage tube.
Insert one end of the hose into the cistern
orifice and connect the other end to the
bathtub, outdoors, a bucket-like recipient,
or to a designated drainage area.
How to correctly place the drainage hose
In continuous drainage mode, the hose
should be placed below the drainage
orifice. Avoid uneven surfaces and do not
bend the hose.
WARNING
Do not block the drain or drainage tube.
Do not bend the drainage tube. The height
of the drain should be lower than the
outlet.
The drainage tube should be safely
connected to the outlet.
English
27