Publicité
Les langues disponibles
Les langues disponibles
ATTENTION:
The dehumidifier must be placed in a
vertical position for at least 12 hours
before use.
Do not attempt to replace the power cord
or plug, as this is a dangerous operation.
Have them replaced immediately by a
Flama-authorized technical assistance
service or by similarly qualified technicians
to prevent danger.
DESCRIPTION
1. Control panel
2. Indicator light
3. Lateral grille
4. Water tank
5. Filter compartment
6. Filter
7. Plug for continuous drainage
8. Handle
9. Wheels
10. Display
11. Power button (ON/OFF)
12. Mode button
13. Humidity control button (HUM)
14. Timer button (TIMER)
15. Fan speed button (SPEED)
16. Lock button (LOCK)
OPERATING INSTRUCTIONS
CONTROL PANEL
POWER button (11) - turning the
appliance on and off
Ensure that the water tank is in the correct
position (after turning on the appliance
for the first time, if the full tank indicator
lights up, remove the tank and return it to
the correct position).
Check that the appliance is plugged into
the wall outlet.
After connecting to the power source, all
the indicators and the display will light up
for 1 second and then turn off. Following
an alert sound, the power indicator will
light up and the dehumidifier will enter
standby mode.
Press the POWER button and the
dehumidifier will begin working, with
an initial humidity of 60%, in standard
automatic mode and high fan mode.
Press the POWER button again and the
dehumidifier will stop working.
Disconnect the appliance from the power
supply, unplugging it from the wall outlet.
MODE button (12)
Press the button to change the appliance's
use mode; the corresponding indicator will
light up.
Automatic mode
When the ambient humidity ≥ the defined
humidity + 3%, the fan will begin to
English
25
Publicité
