Publicité
Les langues disponibles
Les langues disponibles
INFORMATION CODES
The washer may display information codes to help you better understand what is occurring with your
washer.
CODE SYMBOL
dc
dS
FL
Hr
LE
LE(1E)
LO
nd
nF
WF405ATPA-03145A-04_EN_20120829.indd 35
WF405ATPA-03145A-04_EN_20120829.indd 35
MEANING
Unbalanced load prevented your
washer from spinning.
Door is open when washer is running.
Your washer failed to lock the door.
This error code appears when the
heater is 96 °C or above.
Your washer has tried to fi ll, but has not
reached the proper water level.
Leak problem or Waterlevel Sensor has
an abnormal reading.
The door will not unlock.
Your washer is not draining.
It can also mean that the unit senses a
small clog while draining.
Your washer has tried to fi ll but was
unsuccessful.
Check if the hot water supply hose is
connected.
SOLUTION
Redistribute the load, press the Start/
Pause button.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Close the door tightly and restart the
cycle.
If the code reappears, call for service.
Call for service.
Call for service.
Call for service.
Make sure the door is fi rmly closed.
Press the Power button to turn off your
washer, then turn it on again. If the
code reappears, call for service.
Clean the drain fi lter. Then, clean the
debris fi lter (See page 30).
If you are in the middle of a wash you
can try this fi rst:
1. Turn off the unit for 10 seconds and
then turn it on again.
2. Select the Spin Only cycle (See page
23).
3. Press the Start/Pause to drain the
water.
If it still does not drain, call for service.
Make sure the water faucets are open all
the way. Check for kinked hoses.
Check the inlet screens on the fi ll hoses.
If you use a Flood Safety Device, then
please remove the device and connect
the water hoses directly to the unit.
You must connect the hot water supply
hose because hot water is supplied by
the Auto Temperature Control (A.T.C.)
function if the temperature of the cold
water is lower than 59°F.
troubleshooting _35
2012-08-31
2012-08-31
12:36:02
12:36:02
Publicité
