Rockford Fosgate FFX3 Installation Et Fonctionnement page 12

A
CCESSORIES
Connecting PUNCH Capacitors
Maintain the power you need to your Type RF Amplifier.
Color Options
Personalize your Type RF amplifier by changing the top and corner plastics to different colors.
Available through our web site or local retailer.
See our website for other accessories to help you get the most out of your system.
www.rockfordfosgate.com – password TYPERFUSA to access the Type RF page.
S
PECIFICATIONS
MODEL- Type RF 2-Channel
Continuous Power Rating (RMS) - Measured at 12.6 Battery Volts
4Ω Load Per Channel
2Ω Load Per Channel
4Ω Load Bridged (mono)
Dimensions:
Height
Width
Length
Battery Fuse Rating (Amp)
(External to Amplifier)
Fuse Type
Signal-to-Noise Ratio
Crossover Slope
Crossover Frequency
Crossover Frequency
Frequency Response
Bandwidth
Damping Factor @ 4Ω (at output connector )
Slew Rate
IM Distortion (IHF)
Acceptable Signal Voltage Range
Protection
Input Impedance
Specifications subject to change without notice
12
All manuals and user guides at all-guides.com
NOMAD - Internal analog-computer output protection
switch shuts down the amplifier in case of overheating.
FFX3
75 Watts x 2
150 Watts x 2
300 Watts x 1
3.175" (8.07cm)
11.6" (29.46cm)
20.09" (51.03cm)
80A
Not Supplied
AGU
>93dB A-weighted
48dB/octave
All Pass/Low Pass/High Pass/Direct
variable from 50Hz to 350Hz
20Hz to 20kHz ±0.5dB
20Hz to 22kHz ±3dB
>200
30 Volts/ms
<0.05%
Variable from 100mV to 6.5V (RCA Input)
circuitry limits power in case of overload. Thermal
20k ohms