Publicité
Les langues disponibles
Les langues disponibles
3. Press the button "SPEED" (D) to switch between a low or high speed of exhaust air. The indication light
lights up at "LOW" (low speed) and "HIGH" (high speed).
4. Press the "SWING" button to activate the swing position. This leaves the air flow from the left move to the right.
ATTENTION:
•
When the internal water collection tray is full, the device stops functioning, and the indication light lights
up on the control panel at "WATER FULL". You have to empty the water collection tray before you can
continue using the device (see 'CLEANING AND MAINTENANCE – Water drainage').
•
If you often use the device to dehumidify the air, you can also use the continuous drainage (see
'CLEANING AND MAINTENANCE – Water drainage').
USAGE - Sleep function
The device has a sleep function. If you turn on this function, the device will operate in its most silent and
energy saving mode.
ATTENTION:
The sleep function only works in the "COOL" mode.
1. Press the button "SLEEP" (figure 1, H) to turn on the sleep function. The device switches to the lowest
and most energy saving mode.
2. Press the button "SLEEP" again to turn off the sleep function.
ATTENTION:
After turning off the sleep fuction the device remains in the "COOL" mode.
USAGE - Timer function
The device has a time switch with which you can automatically turn the device on or off at the end of a set
time.
Automatically turning on
When the device is turned off:
1. Press the button "TIMER" (figure 1, C). The display starts to flicker.
2. Use the "TIMER" button to set the switch-on time between 1 and 24 hours.
3. Wait until the display (A) stops flickering. The switch-on time is set.
4. Press the button "TIMER" again to adjust the switch-on time if desired.
Automatically turning off
When the device is turned on:
1. Press the button "TIMER" (figure 1, b). The display starts to flicker.
2. Use the "TIMER" button to set the switch-on time between 1 and 24 hours.
3. Wait until the display (A) stops flickering. The switch-off time is set.
4. Press the button "TIMER" again to adjust the switch-off time if desired.
USAGE - Remote control
The device can also be controlled with the included remote control. The remote control requires two AAA-
batteries (not included). Open the battery compartment on the underside, place the batteries and close the
lid. The buttons on the remote control function the same as the buttons on the control panel.
For an optimal functioning:
•
Make sure the distance between the ventilator and the remote control isn't greater than 6 metres.
•
Aim the remote control at the device and make sure the direction angle is smaller than 30 degrees.
CLEANING AND MAINTENANCE - General
After a period of time, dust can get into the rosters and the slats of the device.
1. Turn off the device and pull the plug from the socket.
2. Remove the dust of the rosters and slats with a hand brush and/or vacuum cleaner.
3. Clean the casing with a soft, moist cloth. Never immerse the device in water. Make sure no moist can
get into the electrical connections.
45
EN
Publicité
