Brandson Equipment 305663 Manuel D'utilisation page 31

4. Before initial use
Take the device out of the package and remove all the packaging material. Clean
the device as described in "Cleaning and care" before using it for the first time.
5. Initial use
Then insert the power cable plug into the appropriate power supply sockets.
Make sure that you connect the cooler box either to 12V-24V DC (using the
cigarette lighter power cable provided) or to 110V-230V (using the conventional
power cable).
Do not use any voltage that does not match the specification on the typeplate.
5.1 Operation
To start the device, press the "ON/OFF" button on the control panel. To switch off
the device, press and hold the "ON/OFF" button on the control panel for about 5
seconds.
Select display unit between °C and °F: Press and hold the "DOWN" and "SET" keys
for 10 seconds. The temperature unit selection mode is indicated by a flashing
"°C" or "°F" in the display and is available for 5 seconds. During this time, press
the "DOWN" or "UP" keys to switch between units. After 5 seconds of inactivity,
the unit will return to normal operation.
Then touch the "UP" or "DOWN" button to select the temperature unit Celsius or
Fahrenheit. The selected temperature unit appears and flashes on the display for
a few seconds. Then the display automatically returns to the current temperature.
Setting the cooling temperature: Touch the "SET" button once and then the "UP+"
and "DOWN -" buttons to set the desired cooling temperature. The selected tem-
perature flashes on the display for a few seconds, then the display automatically
shows the measured ACTUAL temperature again.
31
English