Brandson Equipment 305663 Manuel D'utilisation page 33

The selected monitor level "H1" or "H2" or "H3" flashes in the display for a few
seconds. A few seconds after setting, the indicator flashes several times before
returning to the current temperature.
7. Operating mode setting
The device has two operating modes:
Operating mode HH: In this mode, the cooling unit works in standard mode. The
LED "on" light turns red.
Operating mode ECO: The cooling unit works in power-saving mode. The LED
"on" light turns green in this operating mode.
Selecting the operating mode: Press the "SET" key twice in succession.
The currently set mode is displayed ("HH" or "ECO").
Now select the desired mode with the "UP" or "DOWN" keys.
The display continues to flash as long as the selection option is still available (ap-
prox. 5 sec.). Afterwards, the selection is accepted and the display changes back
to the current temperature.
8. Cleaning and Care
Disconnect the plug and allow the device to cool down completely before clean-
ing. The device should not be treated with liquids or even immersed in liquids for
electrical safety reasons.
Never use harsh or abrasive cleaning agents.
Wipe the cover with a damp cloth and then dry it completely.
The container may be cleaned with a damp cloth and with some mild cleaning
agent if necessary. Allow the cooler box to dry completely before using it again.
33
English