Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
®
• The PondMAX
FP Series pump can operate in or out of water
threaded hose-tail adaptor, which allow the pump to be connected to hard pipe or flexible hose of various diameters
®
•
The PondMAX
FP Series Pump FP1150/1550/2050: The volute can be angled at 90° in order to use the pump as required
(Fig. 14 and 15, Page 5).
MAINTENANCE
•
Rotating parts need to be regularly accessed for cleaning. To this purpose it is recommended to not use any chemical detergents.
FP550/750:
follow the instructions on, Page 5.
cleaning.
•
FP1150/1550:
follow the instructions on, Page
cleaning.
•
FP2050:
follow the instructions on, Page 6.
Keep the impeller disc attached to the pump motor unit, using one of the free eye bolts. Remove the volute by pushing the outlet pipe
towards the work surface
(Fig. 8, Page
Replace all parts in reverse order: re-introduce the volute in its seating, ensuring that the bushing is positioned correctly on the
•
bottom of the well. When re-inserting the rotor, pay attention to its magnetic power in order to avoid any damage and injury to
the fingers.
•
FP1150/1550/2050: Turn the impeller disk, paying attention to follow the reference marks placed on the impeller and on motor
body of the pump
(Fig. 13, Page
FP2050: Place the volute making sure that the screw lodging is not next to the fastening eyelets. Rotate it clock-wise until the stop,
then insert the screws and screw to fasten it
Put the pump back into the housing, inserting it into the special slides positioned inside. Close the pump with the remaining housing
•
and fasten the screws.
ATTENTION: The rotor is provided with a ceramic shaft, that is wear-resistant, but fragile. Pay utmost attention during maintenance
•
operations.
Fig. 3 SUBMERSIBLE USE
FP550/750
FP1150/1550/2050
(1 outlet position)
(2 outlet positions)
SUBMERSIBLE APPLICATIONS
FOR WATERFALLS USE
FOR FILTERS USE
W A T E R G A R D E N I N G T O T H E M A X
P O N D M A X . C O M
For this operation, carefully read the assembly instructions and follow the illustrations
Unfasten the screws, remove the volute, and take out the rotor and proceed with
6. Unfasten the screws, remove the volute, and take out the rotor and proceed with
After having carefully positioned the pump on the rear cover, remove the screws.
6). Take out the rotor with the impeller and proceed with cleaning.
6).
Screw the volute back onto the pump, choosing the required position.
(Fig. 17, Page
Fig. 4
EXTERNAL USE
FP550/750
(1 outlet position)
EXTERNAL APPLICATIONS
FOR WATERFALLS USE
FOR FILTERS USE
(detailed Fig. 3 and 4, Page
7).
FP1150/1550/2050
(2 outlet positions)
Fig. 5
FP550/750
OUTLET/INLET
HOSE CONNECTOR
FOR HOSES
Ø 3/4" - 1"
(20-25mm)
FP1150/1550/2050
OUTLET/INLET
HOSE CONNECTOR
FOR HOSES
Ø 1" - 1-1/4"
(25-32mm)
ENGLISH
4). The pump is equipped with two multistage
(Fig. 5, Page
from, Page 5 to 7.
Ø 3/4"
(20mm)
Ø 1"
(25mm)
Ø 1"
(25mm)
Ø 1-1/4"
(32mm)
4).
Page 4
Publicité
