FTX DUTBACK GEO FTX5591 Manuel D'instructions page 8

5. TUNING THE STEERING TRIM
STEERING TRIM DIAL
Gently pull the trigger to allow your car to run slowly.
Meantime, tune the steering trim to allow the front
wheels to be aligned by rotating the dial.
6. TUNING THE THROTTLE TRIM
THROTTLE TRIM DIAL
Throttle Trim is used to set the idle speed of the car,
by rotating the dial.
7. TO TUNE THE STEERING AND THROTTLE DUAL RATE CONTROL
STEERING D/R DIAL
The D/R controls the amount of servo travel. You should
adjust this to give maximum steering without any extra
strain on the servo.
Set it to minimum first and then slowly adjust until full
steering is achieved.
THROTTLE D/R
With this dial you can adjust the the maximum power output from your speed control.
8. STEERING/THROTTLE REVERSE
STEERING REVERSE:
To reverse the direction of servo travel for steering (CH1).
THROTTLE REVERSE:
Allows you to electronically switch the direction that the motor operates in
relation to the throttle trigger. For example, if you pull the throttle trigger to
accelerate forward but the model goes in reverse, flip the Throttle Reverse
switch to make the model accelerate forward.
RUNNING YOUR CAR
STEERING
THROTTLE TRIM
STEERING D/R
8