Installation; Right Place For Installation; Attaching The Plastic Wedges; Adjusting The Stands - Beko BFBF2715SS Manuel D'utilisation

3

Installation

3.1. Right place for installation

Contact the Authorized Service for the product's
installation. To ready the product for installation,
see the information in the user guide and make
sure the electric and water utilities are as required.
If not, call an electrician and plumber to arrange
the utilities as necessary.
B
WARNING:
no responsibility for any damage caused
by the work carried out by unauthorized
persons.
B
WARNING:
must be unplugged during installation.
Failure to do so may result in death or
serious injuries!
A
WARNING:
for the product to pass, remove the door
and turn the product sideways; if this does
not work, contact the authorized service.
vibration.
heater, stove and similar sources of heat and at
least 5 cm away from electric ovens.
keep in damp environments.
function efficiently.
remember to leave at least 5 cm distance
between the product and the ceiling and the
walls.
temperatures below -5°C.
The manufacturer assumes
The product's power cable
If the door span is too narrow

3.2. Attaching the plastic wedges

Use the plastic wedges in the provided with
the product to provide sufficient space for air
circulation between the product and the wall.
1. To attach the wedges, remove the screws on the
product and use the screws provided with the wedges.
2. Attach 2 plastic wedges on the ventilation cover as
shown in the figure.

3.3. Adjusting the stands

If the product is not in balanced position, adjust the
front adjustable stands by rotating right or left.
8 /23 EN
Refrigerator / User Guide