Cameo EVOS S3 CLES3 Manuel D'utilisation page 15

Network Settings
Network Mode
IP Address = Setting the IP
address
Subnet Mask = Adjustment of the
subnet mask
Universe = Setting the DMX
universes 1 - 256
Universe Group Setting the DMX
Universe Group
1 - 256
DMX OUT = Output of the
Artnet or sACN
control signal as
DMX signal via the
DMX OUT sockets
SYSTEM INFORMATION (System Info)
Press MODE to access the selection menu. Using the  and DOWN  controls, select the menu item "System Info" (observe arrow) and
confirm with ENTER.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
Network Settings
System Info

Now select the desired sub-menu item again using the arrow keys UP  and DOWN  and display the corresponding information by
pressing ENTER.
System Info
Firmware = Displays device
firmware
Artnet
Select with UP  and DOWN , confirm with ENTER
sACN
Number 1 000- Select numbers 1 - 4 by repeatedly pressing ENTER
255 Change value with UP  and DOWN , confirm with ENTER
Number 2 000-
255
Number 3 000-
255
Number 4 000-
255
Number 1 000- Select numbers 1 - 4 by repeatedly pressing ENTER
255 Change value with UP  and DOWN , confirm with ENTER
Number 2 000-
255
Number 3 000-
255
Number 4 000-
255
000-255 Select value with UP  and DOWN , confirm with ENTER
000-255
Select value with UP  and DOWN , confirm with ENTER
ON = Output of the control signal via DMX OUT activated
OFF = Output of the control signal via DMX OUT deactivated
Disp:
NET:
CTR1-XY:
CTR2-Motor
CTR3-Motor
CTR4-Motor
Vx.x
Vx.x
Vx.x
Vx.x
Vx.x
Vx.x
15