Publicité
Les langues disponibles
Les langues disponibles
5) Hang the Hood
6) Connect to Ductwork
7) Connect Electric
8) Install Chimney
English 6
Place the hood by sliding the round mounting holes in the top of the hood over the
top hood screws. Check and adjust for level. Tighten the screws
Install two lower hood screws from underneath.
Connect hood to ductwork in house.
Plug electrical cord into grounded outlet. Note: The hood requires a 120V AC,
60Hz., 15A Branch Circuit.
Remove protective film from both sections of chimney.
Connect the sections, one inside the other. For recirculation, the slots in the upper
chimney section should be at the end closest to the ceiling. When venting to the
outside, the top section can be turned upside down to conceal the vents.
1/4" (6 mm)
Figure 5:
Figure 6: Install Lower Hood Screws
Hang the Hood
Publicité
