Publicité
Les langues disponibles
Les langues disponibles
Safety
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE AFTER INSTALLATION IS COMPLETE.
IMPORTANT: SAVE FOR THE LOCAL INSPECTOR'S USE.
Important Safety
Instructions
WARNING:
Improper installation, adjustment, alteration, service or mainte-
nance can cause injury or property damage. Refer to this manual. For assistance
or additional information consult a qualified installer, service agency, or manufac-
turer.
•
Have the installer show you the location of the circuit breaker or fuse. Mark it
for easy reference.
•
Be sure your appliance is properly installed and grounded by a qualified tech-
nician.
Equipment and Usage Safety Requirements
•
Before you plug in an electrical cord, be sure all controls are in the OFF posi-
tion.
•
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
•
Use this unit only in the manner intended by the manufacturer. If you have
questions, contact the manufacturer.
•
Before servicing or cleaning the unit, switch power off at service panel
and lock service panel. This will prevent power from being switched on
accidentally. When the service panel cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
•
Installation work and electrical wiring must be done by qualified person(s)
in accordance with all applicable codes & standards, including fire-rated
construction.
•
Sufficient make-up air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to prevent back-
drafting. Follow the heating equipment manufacturer's guideline and safety
standards such as those published by the National Fire Protection Associa-
tion (NFPA), the American Society for Heating, Refrigeration and Air Condi-
tioning Engineers (ASHRAE), and the local code authorities.
•
Due to the size and weight of this unit, two installers are recommended.
•
When cutting or drilling into wall or ceiling, do not damage electrical wiring or
other hidden utilities.
•
To properly exhaust air, be sure to duct air outside. Do not vent exhaust air
into spaces within walls, ceilings, attics, crawl spaces, or garages.
•
Install this hood in accordance with all requirements specified.
•
The hood is equipped with an internal blower. Other ventilator blowers CAN-
NOT be substituted.
•
WARNING - TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCT-
WORK.
•
WARNING: Turn off power circuit at service panel and lock out panel before
wiring this appliance.
English 1
Publicité
