Télécharger Imprimer la page

SEVERIN 910.033 Série Mode D'emploi page 7

Masquer les pouces Voir aussi pour 910.033 Série:

Publicité

Les langues disponibles

Les langues disponibles

rich juices to be extracted from fruit and
vegetables.
- To preserve the maximum vitamin
content, the juices are best drunk fresh, ie
immediately after extraction.
To store, place the fresh juice in the
refrigerator in a covered container.
- It is advisable to use glass or plastic
containers, since metal containers might
affect the taste.
- After cleaning, cut up the fruit or
vegetable so that it fits down the feeder
tube. Before extracting juice from fruit or
vegetables with stones, please remove
any stones to prevent damage to the
appliance; in addition, removing the
cores optimises the juice extraction.
- The following fruits and vegetables are
not suitable for juice extraction: figs,
grapes,
avocados,
raspberries, blackberries, currants,
elderberries, rhubarb, blueberries,
cranberries, beetroot etc.
- Tomatoes should be lightly carved in
with a knife before juice extraction.
- Bananas should be added for aromatic
purposes only, as very little juice can be
extracted.
Short-time operation
The appliance has been designed for short-
term operation only, i.e. it should not be
operated continuously for more than 1
minute. Switch off the appliance afterwards
and allow the motor to cool down for 1
minute before switching it on again.
Before using for the first time
- Before the appliance is used for the first
time, it must be cleaned as described in
the section General Care and Cleaning.
Switch
The appliance is equipped with a 3-position
switch.
0
appliance switched off
1
slow juice extraction
2
fast juice extraction
910033 de-en-fr-nl ma 2012
We recommend starting extraction with the
slow setting and switching to the faster
setting only when necessary.
Operation
- Place the filter base onto the drive unit.
- Fit the filter and grating plate insert in the
aubergines,
- Place the transparent lid onto the filter
- Place the juice container directly
- Place the pulp container underneath the
- Insert the plug into the wall outlet and set
- Feed the cleaned and pre-cut fruit or
- When processing large quantities of fruit
- After use, switch the appliance off and
Juice container
The juice container incorporates a
removable foam screen. If the juice is
poured through the screen located on the
Ensure that the three locating points on
the filter base are properly aligned with
the three corresponding holes on the
drive unit.
filter base and push the insert down until
it is heard locking into place. It is
essential that the filter is properly locked;
otherwise, if it is not correctly connected
to the drive shaft, damage may occur
during operation. Check that the insert is
properly and securely fitted by manually
turning the filter and grating plate insert
slightly in a clockwise direction; if it can
be easily turned, it is correctly fitted.
base and use the two locking clamps to
lock the lid to the base; this will activate
the safety switch.
underneath the juice outlet.
pulp outlet.
the switch to the required setting.
vegetable pieces down the feeder tube
while the unit is running. Use the pestle
and lightly push the pieces down.
Excessive pressure may result in damage
to the motor or grating plate!
or vegetables, the pulp container and
juice container must be emptied from
time to time as necessary.
remove the plug from the wall socket.
7/14

Publicité

loading