Publicité
Les langues disponibles
Les langues disponibles
DIMENSION GUIDE
Approved Built-In Oven and Gas Cooktop Combinations
A
D
F
I
G
N
M
A. 24" (61 cm) cabinet depth
B. 1" (2.5 cm) clearance to bottom of countertop
C. 25" (63.5 cm) countertop depth
D. Recommended oven junction box locations
E. 1" (2.5 cm) clearance to cabinet
F. 27
⁄
" (70.5 cm) minimum cutout height
3
4
G. Allow 5/8" (1.6 cm) for oven trim to overlap on each side.
H. 36" (91.4 cm) from cabinet base to countertop
I.
31
⁄
" (79.7 cm) from top of countertop to bottom of cutout
3
8
J. Gas line through wall 10
⁄
1
K. 3
⁄
" (8.3 cm)
1
4
L. Gas line through floor 10
1
M. 3
⁄
" (8.9 cm)
1
2
N. 4
⁄
" (11.7 cm) maximum from cabinet base with feet installed.
5
8
O. 25
/
" (64.8 cm) minimum oven cutout dimension
1
2
For the approved model number combinations, refer to the
undercounter label located on top of the oven chassis.
NOTE: For undercounter installation, it is recommended that
the junction box for oven be located in the adjacent right or left
cabinet. A 1" (2.5 cm) minimum diameter hole should have been
drilled in the upper rear right or left corner of the side wall
surface to pass the appliance cable through to the junction box.
The upper shaded areas are recommended locations for
recessed junction box for 120 V grounded outlet for cooktop.
Lower shaded areas are recommended locations for flexible or
rigid gas pipe installation. The gas connection on the cooktop
is on the right (same location as "J" in the above diagram).
The gas pipe can be installed on either side of the cutout, and
either through the floor or through the wall. Refer to local codes
regarding the use of gas lines.
B
D
E
E
J
K
L
O
" (26.7 cm) to center of cutout
2
⁄
" (26.7 cm) to center of cutout
2
Electrical Requirements
C
H
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrical installer determine that
the ground path and the wire gauge are in accordance with local
codes.
Check with a qualified electrical installer if you are not sure the
oven is properly grounded.
This oven must be connected to a grounded metal, permanent
wiring system.
Be sure that the electrical connection and wire size are
adequate and in conformance with the National Electrical Code,
ANSI/NFPA 70-latest edition or CSA Standards C22.1-94,
Canadian Electrical Code, Part 1 and C22.2 No. O-M91-latest
edition, and all local codes and ordinances.
A copy of the above code standards can be obtained from:
WARNING
Electrical Shock Hazard
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
5 of 18
Publicité
