Illustrations
The illustrations referred to in the text
are shown on the fold-out pages at
the end of these operating instruc-
tions.
Connection
Attaching the suction hose
(Fig. 01 + 02)
Insert the hose connector into the
suction opening on the vacuum
cleaner until it clicks into position. To
do this, line up the guides on the two
pieces.
If you want to separate the pieces
again, press the release catches at
the side of the hose connector, and
pull the hose out of the suction open-
ing.
Connecting the suction hose to the
handle (Fig. 03)
Insert the suction hose into the
handle until it clicks into position.
Connecting the handle to the suction
tube (Fig. 04)
Insert the handle into the suction tube
until it clicks into position. To do this,
line up the guides on the two pieces.
To detach the handle from the suction
tube, press the release catch and pull
the handle out of the suction tube,
twisting it slightly as you do so.
Connecting the telescopic tube to
the floorhead (Fig. 05)
Push the telescopic tube into the
floorhead and turn it clockwise or
anti-clockwise until it clicks into posi-
tion.
To detach the floorhead from the suc-
tion tube press the release button
and pull the suction tube away from
the floorhead, twisting it slightly as
you do so.
Inserting batteries into the LED
handle (Fig. 06 + 07)
(depending on model)
Loosen the screw on the cover.
Press in the sides of the cover to re-
lease the retainers and remove the
cover.
Take out the battery holder and in-
sert the 3 batteries supplied. Make
sure the polarity is correct.
Refit the battery holder. Arrows are
marked on the battery holder and
battery compartment as a fitting aid.
They should point in the same direc-
tion.
Replace the cover and tighten the
screw back up again.
Activating the timestrip® filter
change indicator on the exhaust filter
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (Fig.
08):
a AirClean
b AirClean Plus 50 (light blue)
en
47