Safety Agency Compliance
Statements
Read this section before beginning any procedure.
The following text provides safety precautions to follow
when installing a Sun Microsystems product.
Safety Precautions
For your protection, observe the following safety
precautions when setting up your equipment:
Follow all cautions and instructions marked on the
■
equipment.
Ensure that the voltage and frequency of your power
■
source match the voltage and frequency inscribed on
the equipment's electrical rating label.
Never push objects of any kind through openings in
■
the equipment. Dangerous voltages may be present.
Conductive foreign objects could produce a short
circuit that could cause fire, electric shock, or damage
to your equipment.
Symbols
The following symbols may appear in this book:
Caution –
and equipment damage. Follow the
instructions.
Caution –
Surfaces are hot and may cause personal
injury if touched.
Caution –
To reduce the risk of electric shock and danger
to personal health, follow the instructions.
There is a risk of personal injury
Hot surface. Avoid contact.
Hazardous voltages are present.
Annexe C Déclarations de conformité aux normes et aux règles, ainsi qu'aux normes de sécurité
Depending on the type of power switch your device has,
one of the following symbols may be used:
On –
Applies AC power to the system.
Off –
Removes AC power from the system.
Standby –
standby position.
Modifications to Equipment
Do not make mechanical or electrical modifications to the
equipment. Sun Microsystems is not responsible for
regulatory compliance of a modified Sun product.
Placement of a Sun Product
Caution –
openings of your Sun product. Never place a
Sun product near a radiator or heat register.
Failure to follow these guidelines can cause
overheating and affect the reliability of your
Sun product.
Noise Level
In compliance with the requirements defined in DIN 45635
Part 1000, the workplace-dependent noise level of this
product is less than 70 db(A).
The On/Standby switch is in the
Do not block or cover the
49