Publicité
Les langues disponibles
Les langues disponibles
Installation
26
English
A2-WW6900_WASHER-MD_SimpleUX_03645H-00_EN.indd 26
3. Put the other ends of the hoses into a bucket
and open the taps for 10-15 seconds to remove
impurities. When done, close the taps.
4. Attach the water hoses to the hot and cold water
inlets on the back of the washer, and then hand
tighten the water hose fittings until they are
tight. Then, use pliers to tighten the fittings by an
additional two-thirds of a turn.
NOTE
If you do not want to use the hot water supply hose,
attach the water intake cap to the hot water supply
intake. When you do a wash, press Temp. to select Cold.
5. Open the water taps, and check for leaks.
2022/12/31 11:17:15
Publicité
