Samsung WW25B6900AW Mode D'emploi page 25

STEP 4 Connect the water hose
A2-WW6900_WASHER-MD_SimpleUX_03645H-00_EN.indd 25
CAUTION
• Make sure you use a new water hose, and there are
rubber gaskets (B) inside the couplings (A) at either
end of the water hose. A water hose without the
gasket may cause a water leak.
• If there is a water leak, stop using the washer and
contact a local Samsung service center. This may
cause electric shock.
• Do not stretch the water hose by force. If the hose
B
is too short, replace the hose with a longer, high-
pressure hose.
• To prevent leaks, make sure both water hoses are
not bent or kinked. A water leak may cause electric
A
shock.
1. Attach the water hoses to the hot and cold water
taps, and then hand tighten the water hose fittings
until they are tight. Then, use pliers to tighten the
fittings by an additional two-thirds of a turn. To
avoid damaging the fittings, do not overtighten
them.
2. Pull the water hoses to check if they are firmly
connected.
English 25
2022/12/31 11:17:14