Télécharger Imprimer la page

Craftsman CMXCAFG190682 Guide D'utilisation page 17

Pulvérisateur sac à dos alimenté par batterie de 15l

Publicité

Les langues disponibles

Les langues disponibles

Cap and Filter Basket Maintenance
• Check the check valve (2) on the cap (1) and the
filter basket gasket (3) on the filter basket (4) to
ensure they do not show signs of wear and are
operating properly.
• Replace them as required.
Fig. 16
1
2
3
4
In-Tank Filter Maintenance
CAUTION: RISK OF DAMAGE TO INTERNAL
COMPONENTS. Do not operate the sprayer without
the in-tank filter properly installed. Doing so could
allow debris to enter the pump and cause clogging or
damage to the pump.
1. Ensure the sprayer is OFF and remove the
battery according to the Removing the Battery
instructions.
2. Remove the cap and filter basket. Rinse with
clean water to remove any debris.
3. Place the filter basket and cap on a clean surface
where they will not collect dirt, dust, grass
clippings, or other debris.
4. Pour any liquid from the tank into an
appropriate container for later use or proper
disposal according to chemical manufacturer's
instructions.
5. Rinse and empty the tank to remove any dirt,
debris, or residue.
6. Reach into the tank and carefully grasp the in-
tank filter (1) located at the bottom of the tank.
7. Turn the in-tank filter approximately 1/8 of a turn
counterclockwise until it stops turning and pull
up to remove it from the tank.
8. Clean the in-tank filter carefully rinsing from
the inside to the outside. Be sure not to tear or
damage the mesh. Any damage to the mesh
may allow debris to enter the pump and cause
clogging or damage to the pump.
NOTE: If the in-tank filter is damaged or too dirty to
permit cleaning, replace with a new in-tank filter.
9. To re-install the in-tank filter, gently set it back
over the filter base in the bottom of the tank, and
slowly turn the filter clockwise until the locking
tabs on the filter base align with the grooves in
the filter. The in-tank filter will drop downward
approximately 1/8 in. when this happens.
10. Push down on the in-tank filter until it stops,
approximately another 1/4 in., then turn the
in-tank filter approximately 1/8 turn clockwise
until it stops.
Fig. 17
ENGLISH
1
17

Publicité

loading