Publicité
Les langues disponibles
Les langues disponibles
Installing the Range Hood
1.
Using 2 or more people, hang range hood on 2 mounting
screws through the mounting slots on back of hood.
A. Mounting screws
B. Mounting slots
C. Lower mounting screws
B
C
2.
Mark with a pencil the lower mounting holes location.
3.
Uninstall the hood assembly, and drill
at marked locations.
4.
Hang the range hood again on 2 upper mounting screws.
5.
Level the range hood and tighten upper mounting screws.
6.
Install 2 - 5 x 45 mm lower mounting screws and tighten.
7.
Use the optional wall anchors if needed.
Connect Vent System
1.
Install transition on top of hood (if removed for shipping) with
2 - 3.5 x 9.5 mm sheet metal screws.
For vented installations only:
1.
Fit vent system over the exhaust outlet.
2.
Measure from the bottom of the air deflector to the bottom of
the hood outlet. Cut the ductwork at the measured dimension.
Roof
outlet
Wall
outlet
3.
Seal connection with clamps.
4.
Check that back draft dampers work properly.
A
⁄
" (4.8 mm) pilot holes
3
16
A
B
A. Vent transition
B. 3.5 x 9.5 mm screw
Dimension
to measure
Electrical Connection
WARNING: Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.
Disconnect power.
2.
Remove terminal box cover.
3.
Remove the knockout in the terminal box cover and install a
UL listed or CSA approved
A
4.
Run home power supply cable through strain relief, into
terminal box.
A. Home power supply cable
B. UL listed or CSA approved strain relief
C. Black wires
5.
Use UL listed wire connectors and connect black wires (C)
together.
6.
Use UL listed wire connectors and connect white wires (E)
together.
WARNING: Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box. Failure to do so can result in death or
electrical shock.
7.
Connect green (or bare) ground wire from home power supply
to yellow-green ground wire (F) in terminal box using UL listed
wire connectors.
8.
Tighten strain relief screw.
9.
Install terminal box cover.
10.
Reconnect power.
6
⁄
" strain relief.
1
2
C
B
D. UL listed wire connectors
E. White wires
F. Green (or bare) and yellow-green ground wires
Publicité
