Xo XOC24SMUA Notice D'utilisation page 10

1
B
2
F
Min 0-1/2"
Max 1/016"
Fig.4
1. FIXING THE HOOD TO THE LOWER PART OF THE WALL CABINET:
Follow the steps below:
1- Position template B on the wall unit, bearing in mind the measurements indicated in
fig. 1-2 and the minimum distance from the hob.
- Mark the references to fix brackets A to the wall unit, as indicated in figure 4.
2- Make sure the thickness of the wall unit is within the parameters indicated in figure
4 - step 2.
3- Build the hood in the wall unit and make sure the 2 side springs F are connected cor-
rectly. Fasten the hood to the wall unit using the screwdriver and the relative screws M
and tighten until the device is firmly against the wall unit (figure 4 - step 2).
4- Remove pin Y from bracket A. Then place the insert X on the slot of the bracket A, as
indicated in figure 4 - step 3.
- Match the C screws with the L wascher and fix the A bracket to the cabinet as indicated
in figure 4 - step 3.1. Pay attention not to completely tighten screws C before the bracket
24" - 36" - 30"
A
3
2
F
- 10 -
4
2
1
M