Publicité
Les langues disponibles
Les langues disponibles
INSTALLER CHECKLIST
Your installer must have completed and checked the following:
The dishwasher is square and level.
•
•
The dishwasher is fastened securely to the cabinetry.
The dishwasher door opens and closes freely. The dishwasher door must close without hitting any cabinetry
•
or counter top. The inlet water supply is turned on and checked for leaks.
The drain hose has been connected and checked for leaks. There must be no kinks or obstructions in the
•
drain hose.
The drain hose must be installed with a 28" (710mm) high drain loop for drain hook-ups without any air
•
removed.
•
If the dishwasher drain is hooked up to a garbage disposal, the drain hopper plug must be removed.
•
The spray arms are free and rotate freely. The rinse cycle has been run.
•
screen after the end of the wash program.
•
•
Set the water softener to the correct water hardness for your area. If the dishwasher drain is connected to a
•
garbage disposal, make sure that the drain/hopper plug has been removed.
FINAL INSTRUCTIONS
1. Press the On/Off button to turn the dishwasher on.
2. Power indicator light comes on.
3. Use the Program Select button to choose a washing program.
4. Start the program with the Start/Pause/ Cancel button.
5. Run the dishwasher through one complete cycle. When the wash cycle is completed, use the On/Off button to
turn the dishwasher off.
SELF HELP HINTS:
The screen does not come on:
Check to make sure the circuit breaker to the dishwasher is in the on
position. Check to make sure that the Supply cord is plugged.
No Water is coming into the dishwasher: Check to make sure the hot water shut- off is in the ON position.
Water does not drain:
Make sure drain hose is not kinked or comes out of air gap next to the sink. Remove drain hose from
disposal making sure plug is removed.
Notice :
If your dishwasher is not operating properly after following these steps: Contact your dealer to schedule
an authorized service agent to inspect your new dishwasher for any function related failure.
The manufacturer warranty does not cover installation, conversion or customer education service visits.
AVANTI PRODUCTS
M IAMl,FL 33172
VOLTS
120VAC
12AMPS
TOTAL AMPS
You will find the model and serial number information on the label located on the right-hand side of the
inner door of your dishwasher, as shown above.
Notice :
Please make a copy of your invoice and keep it with this manual and register your dishwasher.
Notice :
If the dishwasher does not operate properly, refer to the self-help hints.
USA
DISHWASHER
I En er gy Ver ifi e d c@ us
c
\lh"\
�L
,
C�.J
E496149
60 Hz
0,9A
ID:57 2244 �� ��T�U�R=K
16
LISTED
Single
1100W
Publicité
