Publicité
Les langues disponibles
Les langues disponibles
d)
Remove adjusting tools or wrenches before switching on the electric tool. A tool or
wrench which is located on a turning device can cause injuries.
e)
Avoid abnormal posture. Care for safe standing and keep the balance anytime. Do
not work on a ladder. Thus you can control the electric tool better in unexpected
situations.
f)
Wear suitable clothing. Do not wear wide clothing or jewelry. Keep hair, clothing
and gloves away from moving parts. Wide clothing, jewelry or long hair can be caught
by moving parts.
g)
If there is the possibility to assemble a dust exhauster and collecting device, make
sure that these are connected and used correctly. The use of a dust exhauster can
reduce dangers by dust.
4)
Use and handling of the electric tool
a)
Do not overload the device. Use the appropriate electric tool for your work. With the
appropriate electric tool you work better and saver in the declared range of performance.
b)
Do not use an electric tool whose switch is damaged. An electric tool which can not
be switched on and off is dangerous and has to be repaired.
c)
Unplug the plug from the socket and/or remove the battery before carrying out
instrument settings, exchanging accessories or put the device aside. This safety
measure avoids the unintended start of the electric tool.
d)
Keep unused electric tools out of reach of children. Do not allow persons to use
the device who are not familiar with it or have not read these instructions. Electric
tools are dangerous if they are used by inexperienced persons.
e)
Maintain electric tools with care. Check if movable parts function correctly and do
not jam, if parts are broken or damaged in that way, that the function of the electric
tool affected. Have damaged parts repaired before using the device. Many accidents
originate from bad maintained electric tools.
f)
Keep the cutting tool sharp and clean. Carefully maintained cutting tools with sharp
edges do jam less and are easier to guide.
g)
Use electric tool, accessory, operation tools, etc. according to these instructions.
Thereby consider the conditions of employment and the work to be done. The use
of electric tools for others than the intended task can result in dangerous situations.
5)
Service
a)
Have your tool only repaired by qualified personnel and only with original spare
parts. Thus it is assured that the safety of the electric tool is being obtained.
2.
P A R T I C U L A R I N F O R M A T I O N - Please note
This diamond hand saw is only intended for industrial use and may only be operated by trained personel.
Proper use extends only to the sawing of rock, concrete and masonry.
For operation the relevant regulations must be observed.
Power tools must regularly (approx. 6 months) be checked on safety by a specialist according to DGUV
V3.
Wear ear protection when working with this machine.
The HS45 may only be operated with a guide rail.
3.
T E C H N I C A L D E S C R I P T I O N
Your HS45 is a full electrical hand saw which is only to be used for cutting masonry, stone and concrete
in industrial usage by trained personnel.
Water is absolutely required for cooling the motor.
The diamond saw blade consists of a prestressed metal disk which is at its circuit fixed with segments
made of a sintered mixture of diamond grains and metal powder.
The sawing process is introduced by dipping the saw blade into the material, which is to be cut. After
the cutting depth is reached, the saw is moved manually in longitudinal direction for cutting.
8
Publicité
