Publicité
Les langues disponibles
Les langues disponibles
ZEPHYRONLINE.COM
Optional RF Remote Control
To enable RF remote control capabilities, the remote control accessory kit is required. The part
number for the kit is RC-0002.
FCC Caution
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example -
use only shielded interface cables when connecting to computer or peripheral device. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1)
This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Installation
To install remote control accessory kit, please follow these steps below.
1. Remove grease filters. Remove (2) screws from each side panel.
2. Remove (2) screws on the left and right sides of the light panel. Remove (4) screws attaching
internal cover panel.
3. Connect the red wiring from the remote control control board to red connector in hood PC board.
4. Adhere remote control control board near PC board box.
5. The blue antenna wire needs to be extended for optimal signal. There is no need to secure it.
Synchronization
To create a unique link between your hood and remote control please follow these steps.
1. With hood off, press and hold the ON/OFF and LIGHTS button for 3 seconds. Both the ON/OFF
and LIGHTS button will slowly blink while "PAIRING" appears on the LCD. Pairing mode will remain
active for 60 seconds or until a remote control has been paired. Pressing the ON/OFF button will
cancel pairing mode.
2. Press a button on the remote, and the remote control will be synchronized with the hood.
RF Remote Control Functions
Blower On/
1
2
Speed Selection
3
4
5 Min Delay O
Siena Use, Care, and Installation Guide
Blower On/
Blower On / Speed Selection
1
Power O
Press
Blower On / Power Off
2
By pressing
again and the entire hood will power o , including lights.
Delay Off
3
By pressing
change to speed 1 and a 5 minute timer will begin counting down.
Lights Off/Low/High
4
Switch between light levels by pressing
the di erent light levels. To adjust the color temperature, press and hold
for 3 seconds. Press
again to save the setting.
Lights O /Low/High
Features & Controls
to power on blower and cycle through all speeds.
, the blowers will power on at the last speed setting. Press
, the blower and lights will enter Delay O mode. The blower will
to cycle through the temperatures and press
. Turn o the lights by cycling through
21
Publicité
