Publicité
Les langues disponibles
Les langues disponibles
SAFETY INSTRUCTIONS
Connect the equipment for dust extraction.
the equipment for dust collection is included,
check that these are connected to the tools and
used correctly.
Check that the infeed tube is used correctly.
not drag the tool connected to the power supply
by pulling the tube. Keep the tube away from
sources of heat and sharp objects.
Fasten the part to be worked.
devices to keep the part still. This is safer than
using your hands and in this way they will both
be free for working with the tool. Check that a
firm resting point is always available and that the
position is well-balanced.
Always keep a good grip
the tool, using special auxiliary devices where
necessary. This will serve to reduce body vibration.
Accessories being operated.
and/or accessories of the tool which are moving
or working.
Pay attention.
Always pay attention to what are
you doing. Proceed with care. Do not work when
you are tired.
Look after the tools.
good condition so that better results may be
obtained safely. Never remove protection or
silencers from the tool. Follow instructions for
maintenance and for replacing the accessories.
Use and assembly of the accessories.
be done according to the machine instructions
manual. The use of accessories or assembly other
than those recommended may cause personal harm.
Switch off the power supply.
and before performing calibration, maintenance or
replacement operations on the accessories such
as impact sockets, etc., you are recommended to
switch of the power supply to the tool.
Remove the service keys.
always check that the service or adjusting key has
been removed.
Check damaged parts.
Use fastening
on the handle of
Do not touch parts
Keep them clean and in
This should
After each work session
Before using the tools,
When the goods are
If
received, check that the packaging is intact
and there are no signs of knocks or tampering.
Before using the tool, carefully check that the
safety device and other parts are in perfect
Do
working conditions.
Check that the moving parts are not damaged,
that they are free to move, and check any other
conditions that could limit the operation of the
tool.
A
damaged
component must be replaced or repaired by
an authorised Servile Centre unless otherwise
indicated in this manual.
The tool does not emit non-ionizing radiation.
IMPORTANT.
The use of accessories and spare
parts other than those recommended in this
manual may cause personal harm.
Do not alter any element of the machine
remove protective or safety devices, or elements
for checking the outgoing air flow (filters,
deflectors, etc.) without explicit authorisation
from PAOLI.
Stop work
immediately should vibrations or
strange noises occur, or if the tool starts operating
differently.
The tool should be repaired by a qualified
personnel.
This compressed air tool complies
with current safety regulations. Repairs must be
done by qualified personnel, using original spare
parts, otherwise serious harm may be caused to
the operator.
protective
device
ENGLISH
ITALIANO
ITALIANO
or
other
or
15
15
Publicité
