Connection Diagrams - Alto Professional RMX2408DFX Guide D'utilisation Rapide

CONNECTION DIAGRAMS

AMPLIFER MODE
Main Speaker- 4 ohm
minimum load per speaker
Speaker- 4 ohm minimum
load per speaker
The RMX 2408 is equipped with NL4 type Speakon™ output jacks. When connected to a 4 conductor
speaker wire, 2-Channels of audio can be carried on one cable. NL4 connectors can also be used to
bridge two amplifier channels for mono output.
When using the RMX 2408 in 500W X 2 + 500W X 2 mode, the L and R Speakon™ outputs can be
used to power a stereo pair of speakers per L and R output jack. (In this mode, it is possible to power 2
stereo speaker pairs.)
To drive a pair of speakers at the L or R Speakon™ outputs, use a Speakon™ NL4 to Speakon™ NL2
splitter cable. The diagram below illustrates Speakon™ splitter wiring.
Note: In 500W X 2 + 500W X 2 mode, the minimum speaker load is 4 Ohms per channel.
1+, 1-, 2+,2-
AMP(R) Speakon™ Jack
Right Speakon
AMP(L) Speakon
Left Speakon
Use either the
Speakon™ jacks or
phone jacks
Speakon
*
From Amp (L)
Connector to Left Speaker
™
Speaker
Jack Speaker Jack
™ ™
Connector to Left Speaker
™
4 pole to 2 pole splitter
AMP(R) Speakon™ Jack
Right Speakon
™
AMP(L) Speakon
™
Left Speakon
8
Main Speaker- 4 ohm minimum
load per speaker
Speaker- 4 ohm minimum load
per speaker
1+,1- (CH -1)
To Speaker Speakon
Connector
2+,2- (CH -2)
To Speaker Speakon
In Connector
Speaker
Connector to Right Speaker
Speaker
Jack
Connector to Right Speaker
™
In
™
™