Rear Panel - Alto Professional RMX2408DFX Guide D'utilisation Rapide

REAR PANEL

35. POWER SWITCH – Turns the
mixer on and off. Turn on the
mixer after all input devices
have been connected
before you turn on amplifiers.
Turn off amplifiers before you
turn off the mixer.
36. POWER IN – Use the included
IEC power cable to connect the
mixer to a power outlet. While
the power is switched off, plug
the power supply into the mixer first, then plug the power
supply into a power outlet.
available in your country and how the voltage for your
RMX2408DFX is configured before attempting to connect
your RMX2408DFX to the main AC.
37. SPEAKER JACKS – These jacks are used to connect
speakers. They are configured with 1/4" phone jacks and
4-way Speakon
™
NL4 connector mated to a 4 conductor speaker cable
should be used. You can determine the signal that is
output to these jacks according to the setting of the
AMPLIFIER MODE select switch. See page 35 for setup diagrams.
Note: In order to avoid damage to the built-in amplifier, please pay attention to the allowed impedance
of the speaker. Very low load impedances may damage the amplifier. Look at the plate on the back of
your unit for reference.
!
Caution: Do not connect the rear panel speaker level ¼" outputs to anything other than a passive
loudspeaker. Connecting this output to a line line/Mic level input may damage your equipment.
and
Please check the voltage
connectors. For optimal performance, a
35
36
WARNING:
preset to US voltage. Units purchased in
EU/UK are preset to 220/240 voltage.
Adjustment should not be made unless
you're traveling to other countries or are
in a
Selecting an improper voltage can damage
the unit.
6
Units bought in the US are
country with varying
37
37
37
voltage.