Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION
1.
Auto off
Shot of steam button
2.
3.
Variable steam control
•
Dry ironing
•
Steam max. position
4.
Cord
5.
Handle
6.
Spray trigger
7.
Thermostat control light
BEFORE USE
WHAT WATER MAY BE USED ?
Your iron has been designed to operate using untreated tap water. If in doubt, check with
your local water authority. However, if your water is very hard, you can mix 50% untreated
tap water with 50% distilled or demineralised water.
The types of water listed below contain organic waste or mineral elements that
can cause spitting, brown staining or premature wear of the appliance: water from
tumble dryers, scented or softened water, water from refrigerators, batteries or air
conditioners, pure distilled or demineralised water or rain water should not be used in
your iron. Also do not use boiling, or bottled mineral water.
IMPORTANT Heat concentrates the elements contained in water during evaporation.
USE
1 • Filling the water tank
IMPORTANT Before doing anything else, remove the soleplate
protector Warning! Before using your iron with the steam function
for the first time, we recommend that you operate the steam in
a horizontal position for a few moments, away from your linen,
i.e. press the burst of Steam button a few times. During the first
few uses, a harmless odour and a small amount of smoke may be
noticable. This has no effect on the use of the iron and will cease
quickly.
• Before filling
the water tank,
unplug the iron.
8.
Water tank
Self clean button
9.
10.
Spray
High precision tip
11.
12.
Soleplate
13.
Filling inlet
14.
Temperature control dial
15.
Rear Cover
• Open the filling
inlet. Fill in water
up to the Max.
mark. Close the fil-
ling inlet and return
the iron to the hori-
zontal position.
2
• Set the temperature
control dial on Min.
mark.
• Plug in your
iron.
Publicité
