Gorenje ora-ito S1 BHP643ORAB Instructions page 33

Buttons T7 and T8 are not visible at this stage (on some models). They are visible only as described
in operation section of the manual.
Approximate distance of button T7 from T6 is 16 mm, and distance of but-
ton T8 from T7 is 26 mm.
Setting of Automatic Operation parameters
For correct use of the automatic operation, perform "Hood Calibration".
Hood Calibration
With the display on (ON) and the suction off (OFF), press button T3 for 5 seconds.
The suction speed (power) 1 starts functioning and button T3 flashes to indicate that hood calibration is
initiated and it will last for approx. 5 minutes.
Note: to interrupt the calibration, press T3 for 5 seconds; the calibration will be invalidated and should
therefore be repeated.
MAINTENANCE
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical
supply by switching off at the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed
from the socket.
CLEANING
The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out
maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid
detergent. Do not use abrasive products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and
replacement of the filters may cause fire risks. Therefore, we recommend observing these instructions.
The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to
inappropriate maintenance or failure to observe the above safety recommendations.
GREASE FILTER
Traps cooking grease particles. The grease filter must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering
capacity. To remove the grease filter, press it and pull it down.
CHARCOAL FILTER
It absorbs unpleasant odours caused by cooking. The saturation of the charcoal filter occurs after more or
less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least every four mounths. The charcoal filter may
NOT be washed or regenerated.
REPLACING LAMPS
The hood is equipped with a lighting system based on LED technology. The LEDs guarantee an optimum
lighting, a duration up to 10 times as long as the traditional lamps and allow to save 90% electrical energy.
For replacement, contact the technical service.
(filter version only)
T6 T7 T8
16 mm 26 mm
EN 33