Programming The User Code; Programming The Master Code; Fitting/Changing Batteries - BOLERO GC608 Mode D'emploi

UK

Programming the User Code

The user code can be any 3-8 digit number, and is intended for use by guests.
With the safe door open and still UNLOCKED:
1. Input the new user code.
2. Press the '#' button to confirm and store the code.
3. Close the door, turning the handle anti-clockwise to lock it.
Note: Close the door within 5 seconds or the appliance times out. Re-enter the
user code to release the lock and close the door.

Programming the Master Code

The master code can be any 3-8 digit number, and is intended for use by staff.
With the safe door open and still UNLOCKED:
1. Press the '0' button twice, followed by the # key.
2. The yellow light illuminates to signal the keypad is ready.
3. Input the new master code.
Note: The code must be entered within 20 seconds or the appliance times out.
4. Press the '#' button to confirm and store the code.
Note: Close the door within 5 seconds or the appliance times out. Re-enter the
user or master code to release the lock and close the door.

Fitting/Changing Batteries

The red and green lights illuminated together
indicates low battery power and the batteries must
be replaced.
1. Open the safe door.
2. Remove the battery cover on the inside of the
door.
3. Fit/replace the batteries (4 x AA).
WARNING: Check the batteries
are fitted correctly and the
keypad has power before locking
the safe door.
Note: It is advisable that all four batteries are changed at the same time.
4
GC608_ML_A5_v3_20190927.indb 4
Battery compartment cover
2019/9/27 17:05