Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
d. Assemble the ratchets (Part #13) to the web ends on the
4 corner of the cover, 1pc for each corner.
e. Insert the "S" - hook on ratchet into hole on the Bent
Corner Leg. Wind the ratchet so that the webbing
overlaps itself. Do not over tighten.
f. Follow below Diagram N, lacing the Cover with the
bottom Cross Rails through the eyelets on the Cover
bottom part. Make sure the Cover is even in front & back,
also even in the 2 sides. Lacing the Cover tight on the
frame.
g. Tight the Ratchet again based on the Tarp tightness.
NOTE: Over-tightening can cause damage to
straps and/or the anchor point.
DO NOT over-tighten!
The shelter is now ready for use.
Note: Please check periodically (two to three times
in the first week - weekly for the balance of the first
month of set up) and tighten ratchet tie-downs and
all hardware as needed. Monthly inspection is
recommended throughout usage.
Disassembly
When disassembling the shelter, depress the spring-
loaded bar and open ratchet handle completely to
allow the webbed belt to disengage the ratchet.
PLEASE RE-READ ALL WARNINGS CONTAINED
ON PAGE 2 OF THESE INSTRUCTIONS. SAVE
THESE INSTRUCTIONS FOR FUTURE USE.
To dismantle, execute all instructions in reverse order.
Store your shelter in a cool, dry location between
seasons to prolong usable life of all components.
Components are not equally durable and will require
replacement over time at differing intervals.
.
Page 9
Diagram N
Publicité
