dBTechnologies VIO S218F Manuel D'utilisation page 43

English
ENDFIRE CONFIGURATION
• Check that the local parameters of the various
modules are set correctly on the individual amplifier
panels. Make the audio, RDNet and power supply link
connection as described in the previous paragraphs.
When powering up, be aware of the inrush
current given in the TECHNICAL SPECIFICATIONS
(e.g. electrical system dimensioning, possibility of
powering up the various subwoofers sequentially).
• When using remote control with RDNet and AURORA
NET, the local settings are bypassed and the software
has control.
STACKED CONFIGURATION
• For safety reasons, no more than 3 modules can be
mounted in a stacked configuration on the DRK-212 flybar.
• Place the DRK-212 flybar on the VIO S218F subwoofer
(installed on a level surface). For further details on this
accessory, refer to the complete manual.
• Add the VIO-L212 modules one by one, at the previously
calculated tilt angles as illustrated in the corresponding
manual.
• Check that the local parameters of the various modules
and subwoofers are set correctly on the individual
amplifier panels. Alternatively, you can remotely change all
parameters in real time or later if you connect the line-array
via the RDNet network (AURORA NET). However, it is good
practice to physically copy at least the initial design setting
onto the VIO-L212 modules before installation. For further
information, refer to the corresponding manual.
• Make the audio, RDNet and power supply link connections
as described in the previous paragraphs.
VIO S218F Cod. 420120416 REV. 1.2
43