dBTechnologies VIO S218F Manuel D'utilisation page 2

Italiano
EMI CLASSIFICATION
EMI CLASSIFICATION
According to the standards EN 55032 and 55035 this is a Class A equipment, designed and suitable to operate for
professional use.
Warning: This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment may
cause radio interference
FCC CLASS A STATEMENT
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
WARNING
Make sure that the loudspeaker is securely installed in a stable position to avoid any injuries or damages to
persons or properties. For safety reasons do not place one loudspeaker on top of another without proper
fastening systems. Before hanging the loudspeaker check all the components for damages, deformations, missing
or damaged parts that may compromise safety during installation. If you use the loudspeakers outdoor avoid
spots exposed to bad weather conditions.
The system shall be powered down after use. Damage to the system can be caused by leaving the system powered
on for extended periods of time while not passing audio. Any damage to the system caused by the system being
powered on for extended periods of time while not in use will not be covered by warranty.
Contact dBTechnologies for accessories to be used with the speakers. dBTechnologies will not accept any
responsibility for damages caused by inappropiate accessories or additional devices.
Features, specification and appearance of products are subject to change without notice.
dBTechnologies reserves the right to make changes or improvements in design or manufacturing without
assuming any obligation to change or improve products previously manufactured.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NFC MODULE
This equipment contains a transmitter module
FCC ID:2ADDV-NFCVIO
IC:12207A-NFCVIO
VIO S218F
Cod. 420120416 REV. 1.2
2