Sanyo DS27225 Manuel D'instructions page 8

USING THE REAR AUDIO VIDEO INPUT JACKS
CONNECTING A VCR OR OTHER EQUIPMENT
Switch off TV and external equipment before connecting
cables. (Cables are not supplied.)
‚
Connect VCR or other equipment's Audio Video Out to
the TV Audio Video Input.
For Mono VCR (Single Audio Jack) connect VCR
Audio Out to TV Audio (L) Input.
OR
x
Connect DVD Player or other equipment's S-Video
Out and Audio Out to the TV S-Video and Audio In
Jacks.
Remote Control
POWER
INPUT RESET
„
1 2 3
1 2 3
What you will need for connections:
‚
AV Cable – 1
O C
PTIONAL ONNECTION
x
S-Video Cable – 1
x
Audio Cable – 1
I Make sure all cable connectors are fully seated on jacks.
I Always match AV cables according to the colors; red for
right audio, white for left audio and yellow for video.
I P ress INPUT key after connecting cables to access
the AV inputs. There is NO need to tune to a blank
channel.
8
Need help?
Visit our Web site at
Back View of VCR
IN
R-AUDIO-L VIDEO
OUT
R-AUDIO-L VIDEO
‚
ƒ
www.sanyoctv.com
Using the S-Video jack overrides the Video (AV2) jack.
ƒ
Press POWER to turn on the TV. Turn on external
equipment also.
„
To access Audio Video inputs, press the INPUT key
to select VIDEO2.
Note: Audio Video Input (AV2) and Component
inputs share the same audio (R/L) input jacks.
IN
FROM ANT.
VHF/UHF
RF
TO TV
CHANN EL
3 4
OUT
Rear TV AV Input Jacks
AUDIO VIDEO
COMPONENT
2 INPUT 2
VIDEO
Y
P L
B
P
R R
S-VIDEO
I A solid Blue screen with the word VIDEO2 displayed,
means that the Video mode is selected, but no signal is
being detected at the Video jacks. Check connections,
turn on external equipment.
1-800-877-5032
or Call
DVD Player
VIDEO OUT
AUDIO OUT
VIDEO OUT
SELECT
S-VIDEO COMPONENT
L R COAXIAL
DIGITAL OUT S-VIDEO OUT
x x
UHF/VHF/CATV
75Ω
COMPONENT VIDEO OUT
Y P /C P /C
B B R R