Grundig MT 8240 WET & DRY Mode D'emploi page 21

All manuals and user guides at all-guides.com
OPERATION ______________________________
2
Insert beard trimming attachment
carefully at the top and press down
until it clicks into place.
3
Loosen the beard hair by combing
the beard in the direction the hair
grows.
C
4 Press the button to switch on the
appliance and start trimming your
beard.
C
5 Press the button to switch off the
appliance after use.
Trimming hair or beard to
a certain length
Please use the comb attachments
6
to .
1
If necessary, remove the attachment
by pressing in both side catches
and lifting off.
2
Insert attachment
7
or (width 30 mm) carefully at the
top and press down until it clicks into
place.
7
4
B
A
(width 38 mm)
Note
The comb attachments fit both cut-
7
ting heads.
comb attach-
ment 4
comb attach-
ment 5
comb attach- -
ment 6
3
Push the comb attachment carefully
and firmly onto the rounded rear
half of the cutting head from above
and let it click into place.
Note
To adjust the small and large adjust-
7
able comb attachments 5 and 6
press the button in the middle of
each attachment and push it up or
down.
C
4 Press the button to switch on the
appliance and start trimming.
2 mm
10, 12, 14, 16 mm
2, 4, 6, 8 mm
ENGLISH 21