GE GTE18M Manuel Du Propriétaire Et Instructions D'installation page 12

INSTALLING THE DOOR HANDLE
HANDLE FASTENERS
1
1. If the door swings needs to be reversed, see
2. Install the handle fasteners with a Phillips
fresh food doors.
2 HANDLE INSTALLATION
1. Attach each handle to the door handle
fasteners with set screws using a 1/8" Allen
wrench.
2. Tighten the set screws at the top and bottom
NOTE: Be sure to remove
if applicable)
For Stainless Steel Handles Only
that covers the door
contact surface shown
in the picture. This
surface from direct
contact with the handle.
12
Installation Instructions
BADGE AND PLUG BUTTON
3
INSTALLATION ON FREEZER
DOOR
1. Remove the plug button from the top, unused
handle mounting hole.
2. Locate the GE Appliances badge in the crisper
pan and remove paper backing.
3. Carefully orient the badge correctly and apply
GE Appliance
badge location for
right swing doors
Plug
button
49-1000592 Rev. 3