Simons Voss Technologies PegaSys Door Handle 4.1 Guide Abrégé page 46

9. Installing the fitting
9. Installing the fitting
Door pre-drilled.
ü
PH2 screwdriver at hand.
ü
TX15 screwdriver at hand.
ü
Vernier calliper at hand.
ü
Pincers at hand.
ü
1. For S, M and L: measure the door thickness.
20
2. For S, M and L: determine the separation points on
the cut-to-length screws L1 and L2.
21
22
3. For S, M and L: trim the cut-to-length screws L1 and
L2.
23
4. For 7 mm spindle: place the adapter sleeve in the
inner handle in such a way that the recess faces the
grub screw.
24
5. Determine your inner handle's direction rotation as
viewed from the inside: clockwise (clockwise =
CW) or anti-clockwise (counter-clockwise = CCW).
25
26
6. Insert the interchangeable plate into the inner
handle as required.
27
28
7. Press the spring plate on one side against the inter-
changeable plate so that the spring is compressed.
29
8. At the same time, hook the spring plate tabs into
the slot in the inner handle.
30
9. Press down the spring plate bracket.
31
9 The inner handle is now ready.
32
10. For 7 mm spindle: insert the adapter sleeve onto
the side of the spindle with the pin.
33
11. Insert the spindle with the pin side into the fitting.
9 Pin will snap into position in the mount.
34
46 / 64
PegaSys Door Handle 4.1 Downward installation
12. For 8.5 mm and 10 mm spindle: slide the adapter
sleeve into the centre of the spindle. Use a punch
and hammer to make an indent in the adapter
sleeve to prevent it from slipping.
35
36
13. Insert the fitting with the spindle into the door.
37
14. Fasten the escutcheon base to the locking cylinder
hole with the L2 screws (PH2, torque: 1.1 Nm).
38
15. Fasten the inner handle firmly with the L1 screws
(PH2, torque 1.1 Nm).
39
16. For FH: insert the dummy cylinder.
NOTE
Feed the blank cylinder into the hole using a screw-
driver
It is difficult to position the blank cylinder correctly, es-
pecially in thick doors.
1. Insert a screwdriver into the hole in the blank cylin-
der.
2. Position the blank cylinder using the screwdriver.
40
41
17. For FH: screw the dummy cylinder firmly into place
(PH2, torque 1.1 Nm).
42
18. Fasten the set screw on the inner handle firmly
(TX15, torque 5.0 Nm).
43
19. Place the two cover plates with the notch facing
downwards onto the escutcheon base and the in-
ner handle.
44
20. Fit the outside handle into position on the fitting.
45
21. Firmly fasten the grub screw on the outside handle
(TX15; torque: 5.0 Nm).
46
Fitting is now installed.
9
EN