COMPONENTS
1x D410 Smart Door
Controller
1x Power supply unit (mains adapter) with up to
four country-specific adaptors
DEVICE
1) Antennas
2x SMA connector for LTE/4G antennas
2) LCD Status display
Blue backlit LCD display for status and quick
error analysis
3) SET setup button
Button to set the device into different
configuration modes, e.g. to reset the device to
factory defaults
4) PWR LED
Power and diagnostic LED to display the
current status of the device
5) SIM Card Slot
Micro SIM Card slot (SIM card not included)
6) LAN/PoE
If not used with LTE/4G mobile network: RJ45 jack
for connecting a network cable (Cat.5 or better)
with the network segment that is attached to the
switch/router that provides an active Internet
connection. Use this port to power the device with
PoE as an alternative to the power supply
7) DIN Rail connector
Connection for DIN rail clip for DIN rail mounting
8) E1 E1
Screw terminal plug for connecting one
external input
6
1x Installation manual
1x Quickstart guide
with Digital Passport
3x Screw connection
terminal plugs and
1x Screw driver
12
4
5
6
7
8
9
9) R1R1 / R2 R2 / R3 R3
Screw terminal plug connecting to three bi-stable
latching relay (max. 24 V DC/AC, 1A)
10) 15VDC -/+ power supply, 1A
Screw terminal plug for connecting a DoorBird
power supply (available separately) to the device as
an alternative to PoE
11) Wall mounting brackets
Holder for wall mounting. Screws and dowels
included
12) LTE/4G antennas
2x LTE/4G Antenna
2x Phillips countersunk
head screws and
dowels
2
3
1
10
11