DoorBird D410 Manuel D'installation page 10

Use DoorBird power supply unit as an alternative to PoE.
Available in our web shop (GTIN/EAN: 4260423867314, P/N: 423867314).
Please take care when connecting the cables and wires. Connecting the cables and wires the wrong
N OT IC E
way may damage the device.
6
INTERNET CONNECTION
Option 1
LTE/4G SIM CARD: INTERNET CONNECTION VIA
LTE/4G MOBILE NETWORK
Make sure that:
• your Micro SIM Card is enabled at least for LTE/4G
or WCDMA/3G and Internet use
• Your provider supports IoT devices. Data only SIM
recommended.
USA: AT&T or T-Mobile with a data only SIM plan
• your device is within the coverage area of your
mobile operator
• your SIM Card has sufficient credit data rate (1GB
per month recommended)
SIM Card preperation:
There are two ways to configure the PIN of the SIM Card.
1a) Change PIN to "0000"
For initial D410 device configuration set the PIN for the
SIM Card to "0000". You can use e.g. a smartphone to
change the PIN of the SIM Card. Then insert the Micro
SIM Card into the Micro SIM Card slot of the D410,
with the gold contacts facing down.
For security reasons, we recommend changing the PIN after the initial D410 configuration using the
DoorBird App.
To prevent the SIM from being locked, the device tests the PIN once. To test the SIM PIN again, press and
hold the SET key for 5 seconds and follow the directions on the display.
SMS Messages
Incoming SMS messages will be forwarded to the email
address provided during device registration in the
DoorBird App.
Option 2
LAN: INTERNET CONNECTION VIA LOCAL NETWORK
Make sure that:
• your network cable have access to the Internet
• your network cable provides PoE, IEEE 802.3af or
higher (only necessary if you do NOT use the power
supply unit)
Connect the device with your network cable which is connected to your Internet router on port "LAN/PoE".
10
• you have the access data (PIN) for your SIM Card
• the LTE/4G antennas are mounted on the device
• your Sim Card PIN is changed to "0000" for intial
setup
• you have inserted the Micro SIM Card into the SIM
Card slot, with the gold contacts facing down
1b) Set SIM Card PIN via LAN and DoorBird App
Connect the device via network cable to Internet (see
Option 2) and following the steps. Afterwards go to
the DoorBird App →
to the Administration area to set your SIM Card PIN.
Roaming connections
If you want to prevent roaming connections contact
your provider to activate a roaming block for your SIM
Card.
• your network provides an IP address (DHCP) e.g.
via Internet router
→ "Administration" and log in