Publicité
Les langues disponibles
Les langues disponibles
6
Types of work
6.1
Using the support leg
On an even working surface, the support leg makes it easier to hold the fastening tool perpendicular as
attention then only has to be paid to lateral alignment. On uneven surfaces it may necessary to retract the
support leg in order to ensure that the fastener guide is perpendicular to the working surface.
6.1.1
Retracting the support leg
1. Push against the support leg to release it from its resting position.
2. Pivot the support leg back through about 230°.
3. Push against the support leg from below until it engages in the retracted position.
6.1.2
Extending the support leg
CAUTION
Risk of pinching the fingers! When folding the support leg back there is a risk of trapping and pinching the
fingers between the support leg and the casing of the tool.
▶ Hold the fastening tool by the grip when extending/retracting the support leg.
1. Push against the support leg to release it from its resting position.
2. Pivot the support leg forward through about 230°.
3. Push against the support leg from below until it engages in the extended position.
6.2
Switching the fastening tool on/off
6.2.1
Switching the fastening tool on
WARNING
Risk of injury! Pressing the nosepiece of the fastening tool against a part of the body may lead to serious
injury due to inadvertent firing and release of a fastener.
▶ Never press the nosepiece of the fastening tool against your hand or any other part of the body.
▶ Press the on/off button.
▶ The spring mechanism can be heard to build up tension and the status indicator lights green.
When battery performance drops, tensioning of the spring mechanism will take longer than with a
fully charged battery.
Battery performance drops at low temperatures.
If you continue to operate the fastening tool after noticing a drop in battery performance, the
fastening tool will switch itself off automatically before damage to the battery cells occurs.
6.2.2
Switching the fastening tool off
▶ Press the on/off button.
▶ The spring mechanism can be heard to release the tension and the status indicator goes out.
6.3
Driving a nail
7
WARNING
Risk of injury by flying parts! When driving a fastener, there is a risk of injury to the body and eyes caused
by splintered fragments of the workpiece and by flying parts of the nail strip.
▶ Wear personal protective equipment and always wear eye protection and protective gloves. Other
persons in the vicinity must also wear eye protection and a hard hat.
WARNING
Risk of injury! Pressing the nosepiece of the fastening tool against a part of the body may lead to serious
injury due to inadvertent firing and release of a fastener.
▶ Never press the nosepiece of the fastening tool against your hand or any other part of the body.
1. Switch the fastening tool on. → page 10
2. Position the nose of the fastening tool at right angles to the working surface and then press it against the
surface, pushing the fastener guide in as far as it will go.
10
English
6
6
2180112
*2180112*
Publicité
