Outside Living Industries ubbink 7524580 Notice De Montage page 9

WARRANTIES - After-sales service
Swimming pool 580 - H130 cm
Warranty conditions:
The swimming pool must be assembled within 48 hours of the package being opened.
For the warranty to be valid, a concrete slab must be in place.
Our warranty covers only the replacement of defective parts. It in no way covers demands for compensation or damages. The general warranty does not apply in the following circumstances:
• Use of the equipment in a way which is not in accordance with the instructions.
• Damage incurred as a result of bad handling during and after assembly. or any changes made to structural elements without the manufacturer's agreement
1) Pump : 2 year warranty (electrical problems) under normal conditions of use. The following are not covered by the warranty: damage due to abrasion or corrosion (particularly in the case of treating the water by
salt electrolysis), damage due to a faulty connection, equipment dismantled or repaired by a third party, breakage of parts (pump stand, pre-filter cover, grooved end fitting), using the pump when it is empty or
immersing the pump (e.g. if the pump house is flooded). The warranty is not valid if the electric cable and/or the plug are replaced, removed or damaged.
2) Liner : 2 year warranty under normal conditions of use. The following are not covered by the warranty: rips, holes, tears, stains (treatment products put straight into the water) stains related to the development
of algae, stains related to decomposing foreign bodies in contact with the liner, stains and discolorations resulting from the impact of oxidising products, discoloration and wear due to materials rubbing on various
surfaces. Distortions in the liner if it has been out of water for more than 24 hours (never completely empty your pool). See the warranty document that comes with the liner.
3) Filter : 2 year warranty under normal conditions of installation and use: tank, drain plug, collar and multiport valve.... The following are not covered by the warranty: problems with waterproof sealing due to
operating at a level of pressure which exceeds the maximum pressure permitted (see instructions for the filter).
4) Skimmer : 2 year warranty on the waterproof seals.
5) Wooden structure : 10 year warranty against rotting and damage caused by insects. The following are not covered by the warranty: changes in the colour of the wood caused by the climate, natural distortions
(splits, cracks, knots and minor flaws in the tongues of the planks which do not have any adverse effect on the mechanical strength of the wood or on the assembling of the pool). The warranty does not cover incor-
rect assembling or storage which may cause the wood for the sides of the pool to become warped (assembling the pool a long time after contents have been taken out of the packaging) or distortion of the planks
by the pressure of the water, which does not have any detrimental effect on the mechanical resistance of the pool. Any additional protection of the wood for the structure can only be undertaken using a product
which is compatible with autoclave treatment.
IMPORTANT : The after-sales service will be available only at point of sale.
Essential records for claiming the warranty:
- Till receipt / proof of purchase.
- Photograph of the damaged part or the problem in question
Shop :
City :
Contact department :
Direct tel :
Code Ref. Désignation
M 7514215 Plank 45 x 145 x 2380 mm
MS 7514216 Upper plank 45 x 135 x 2380 mm
2MS 7514217 Upper 1/2 plank 45 x 67 x 2380 mm
2MI 7514218 Lower 1/2 plank 45 x 77 x 2380 mm
MSS 7514219 Upper skimmer plank 45 x 135 x 2380 mm
MIS 7514224 Lower skimmer plank 45 x 145 x 2380 mm
MR 7504307 Water jet plank 45 x 145 x 2380 mm
PR 7514097 Post 45 x 135 x 1275 mm (reinforcement)
7514114 Sacrifice part 45 x 135 x 280 mm
PF 7514113 L-section finish 28 x 70 x 1260 mm
C 7514048 Console edging 45 x 230 x 170 mm
Wooden stop block for the skimmer flap
7514049
30 x 20 x170 mm
PL 7100201 Pair of rungs for wooden ladder H120/130 cm
T 7514052 Wooden ladder steps/Skimmer flap 28 x 145 x 600 mm
MSD 7514062 Pine outer right skimmer edging 28 x 145 x 826 mm
MSG 7514063 Pine outer left skimmer edging 28 x 145 x 826 mm
MGI 7100220 Pine edging 28 x 145 x 2129 mm Int.
MGE 7100225 Pine edging 28 x 145 x 2253 mm Ext.
7514149 Sandbag (25kg)
R 7514016 Hung 2.06 ml hanging rails
7514750 3-step stainless steel ladder
Poolmax pump
Filter
Flexible pipe, 8m
S Skimmer large
JM Anodised aluminium joint
Ground protection felt
Protective felt for wall
NOTICE 580 - H130-2018/1.indd 9
- Warranty filled out correctly.
- Reference number of the faulty part.
Client :
Address :
City :
Tel :
Qty Qty
Hardware kit
7514696
parcel ASS
66 Code Ref. BREAKDOWN OF THE HARDWARE KIT
A1 7514516 Console + reinforcer bag
3
A2 7514606 Console + reinforcer bag
4
B 7514270 Cradle cache bag
4
C3 7514616 Hung rails bag
1
DMI 7514553 Edging screw bag
DMP2 7514618 Edging screw bag
1
E 7514145 Skimmer flap bag
1
F 7514620 Aluminium edging joint bag
16
G 7514146 Wooden ladder + finishing profile bag
2
16
16
2
1
5
1
1
8
7
3
8
1
1
1
1
1
8
3 PR
2
8
7514326
1
Qté Qté
parcel ASS
7514234
2
3
7514912
1
1
1
1
1
1
1
PL
PR
II / 18-1
Beige 75/100 liner 580 - H130 cm 1
or
Blue 75/100 liner 580 - H130 cm 1
or
Grey 75/100 liner 580 - H130 cm 1
T
08.01.18 10:27