Hercules DJCONTROL INPULSE T7 Mode D'emploi page 47

4. Installation
Connections
1. Connect the power adapter to the DJControl
Inpulse T7 controller.
2. Connect the power cable to the power adapter, and
plug it into an electrical outlet.
3. Connect the USB cable to the DJControl Inpulse T7
controller and to the computer.
4. Press the POWER button on the DJControl
Inpulse T7 controller. The button is pushed in.
5. Make sure that the speakers are powered off or, if
they are connected to an external amplifier, that the
amplifier is powered off. Connect the inputs of the
active speakers to the Master outputs for speakers of
the DJControl Inpulse T7 controller (2 x RCA or
2 x XLR).
6. Adjust the MASTER volume to the minimum level on
the DJControl Inpulse T7 controller, then power on
the speakers.
7. Place the headphones around your neck (and not on
your ears), then connect the headphones to the 1/8" /
3.5 mm mini-jack connector or the ¼" / 6.35 mm jack
connector.
8. Connect the microphone to the Microphone input
(optional).
46