Brandson Equipment 306615 Mode D'emploi page 23

Activate the pairing of the watering control by pressing the left and right ON/OFF button on the device for
approx. 6 seconds until the status LEDs start to flash quickly. The irrigation controller then connects to the
Wifi connection socket.
Note: If you are using both a 2.4 GHz and a 5 GHz network (or other guest networks), please deactivate all
networks except the 2.4 GHz network in the meantime. Make this visible, as the IP socket is addressed and
connected via the network.
Test device
Leave the tap turned off.
1. Press the ON/OFF button on the watering control. The valve inside the timer for manual watering opens
with a "click" sound. After a few seconds, press the button again, the "click" sounds again and the valve
closes.
2. Turn the tap on a little, press the ON/OFF button on the irrigation controller to check whether the water
flows out as expected or switches off. If so, the appliance is working properly. If you are not sure, please
repeat the above steps several times.
3. The test is complete, please leave the tap fully open!
8. Advanced settings of the app
To use the advanced functions of the appliance, such as the schedule or cycle function, it is necessary to press
the symbol of the connected water valve control in the menu. You can set both zones separately by tapping on
the desired zone in the corresponding menu. „Zone 1" is the left water outlet and „Zone 2" is the right water
outlet.
An extended settings menu appears:
Manual irrigation
Water consumption
English
Watering schedule & manual
rain delay
WiFi floor sensor &
water flow meter
Informations
23