Bimar FD-40M Notice D'instructions page 12

• Before connecting the appliance, check that the voltage shown on the data plate matches
that of your electricity, and that the electric plug is grounded.
incompatibility between the plug point and the plug of the appliance, have the plug
replaced with q suitable one by professionally qualified personnel, who will make sure that
the section of the wires of the outlet is suitable for the power drawn by the appliance. In
general, the use of adapters or extension cords is not recommended; if their use is
necessary, they must conform to existing safety standards and their current capacity
(amperes) must not be less than the maximum of the appliance.
• Before each use, check that the equipment is in good condition, that the power cord is not
damaged: if in doubt consult a qualified professional.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
• Keep the appliance away from:
heat sources (e.g. open flame, gas stove, etc.)
-
liquid receptacles (e.g. sinks, etc.) to avoid water splashing onto the appliance or it
-
falling in (minimum distance of 2 meters)
fabrics (curtains, etc.) or floating materials that could obstruct the air intake grille;
-
make sure that the front is free of floating materials (dust, etc.).
• The appliance must not be used in dusty environments or in the presence of floating
materials or used in a room where there is a fire risk.
• Stand the appliance on a smooth, horizontal surface or table; do not place it on a inclined
surface (the appliance could fall over).
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is
complete with its base and support and protection grid.
If in doubt, have the appliance checked or assembled by a qualified professional person. For
assembly, refer to figure.
Attention: always unplug the appliance before you assemble.
12/32
In the event of