Publicité
Les langues disponibles
Les langues disponibles
English
Important notes
about installation
The product must be fitted exclusively
by a specialist sanitary engineer.
To prevent injuries gloves should be worn
during installation.
Generally accepted engineering practices
should be applied. (In particular, compli-
ance with DIN EN 1717 is recommended).
The hot and cold water supplies must
be equal pressured before installation of
mixers by water pressure reducers (pur-
chased separately) at the water supply
inlets to the house.
WARNING
Drain system completely if danger
of frost.
Technical Data
Water supply parameters
Pressure, MPa
Pressure difference between
cold and hot water, %
Hot water temperature, ºС
Cold water temperature, ºС
Thermal disinfection: 70ºC (3 min).
The product is intended for drinking water
only.
It is strongly recommended to use filters
with a mesh size of ≤ 100 microns at the
inlets to the house water supply.
Products are suitable to electric or gas
instantaneous water heaters if they have
sufficient power output to provide the
recommended hot water temperature.
When installing product on a basin, make
sure that water from the surface does
not get inside the mounting hole and, if
necessary, additionally seal the joint. If
this condition is not met, the manufac-
turer and/or seller is not responsible for
possible leaks.
4
Operating range
Maximum
Recommended
0,1-1
0,3
±10
0
≤75
55-65
≤25
10-20
Maintenance
recommendations
To avoid lime spots at the product it is rec-
ommended to be regularly cleaned. The
cleaning should be carried out by soap
solution with the following rinse with water
and removing moisture by dry soft cloth.
Remains of liquid soap, shampoo and
shower gel may also cause damages of
decorative cover. In case of their penetra-
tion onto the diverter housing it should be
thoroughly cleaned with clean water
To avoid damages of product surface it is
forbidden to use abrasive solutions and
pastes for its cleaning.
To avoid changes color of decorative
cover it is forbidden to use chemicals for
cleaning that contain aggressive chemical
substances of acids, alkali, ammonium
chloride and other components containing
chlorine.
Producer reserves the right without prior
notice to introduce alterations into design
and component parts of devices.
Important!
A hygienic shower is not a shut-off valve
and is designed to shut off water only for
temporary water supply. After each use,
it is necessary to turn off the water supply
to the hygienic shower with a faucet or
shut-off valve, and then relieve pressure
in the watering can and hose of the hy-
gienic shower!
Before installing the hygienic shower in
the holder, need to shake off the remain-
ing water from it. If the conditions de-
scribed above are not observed, leaks are
possible, for which the manufacturer and/
or seller are not responsible.
Publicité
