FILL-RITE RD Serie Manuel D'installation Et D'utilisation page 12

|
Safety Testing Certications
This Fill-Rite line of pumps have been safety tested for compliance to
strict regulatory standards. Check the information on the handle of
your pump to determine the certications that are applicable to your
particular model.
The following standards were used to show compliance in North
America:
UL 674 – Electric Motors and Generators for Use in Division 1 Hazardous
(Classied) Locations, 5th Edition.
The following standards were used to show compliance in the European
Union:
Directive 2014/34/EU – Equipment and protective systems intended
for use in potentially explosive atmospheres.
EN IEC 60079-0:2018 Explosive atmospheres – Part 0: Equipment –
General requirement.
EN 60079-1:2014 Explosive atmospheres – Part 1: Equipment protection
by ameproof enclosures "d".*
IEC 60079-0 Explosive atmospheres – Part 0: Equipment – General
requirements, 7th Edition.
RD SERIES FUEL TRANSFER PUMPS
Fill-Rite Company
8825 Aviation Drive
Fort Wayne, Indiana 46809 USA
T 1 (800) 720-5192
1 (260) 747-7524
F 1 (800) 866-4681
fillrite.com | sotera.com | gormanrupp.com
INSTALLATION AND OPERATION MANUAL
IEC 60079-1 Explosive atmospheres – Part 1: Equipment protection by
ameproof enclosures "d", 7th Edition.
Directive 2006/42/EC – Directive on machinery.
EN 809:1998 +A:2009 – Pumps and pump units for liquids – Common
safety requirements.
EN ISO 12100:2010 – Safety of Machinery – Basic concepts, general
principles for design.
Directive 2004/108/EC – Electromagnetic compatibility.
Directive 2011/65/EU – Restrictions of the use of certain hazardous
substances in electrical and electronic equipment.
*The minimum and maximum values of the ameproof joints differ from
what is specied in Table 2 of EN60079-1:2014. Manufacturer is to be
contacted for information on the dimensions of the ameproof joints.
*The fasteners used to secure the steel can to the aluminum housing
have a yield strength of 1100MPa.
DC001582-000 Rev.6